Aerodrome Flight Information Service (AFIS)
Introduction to AFIS
Aerodrome Flight Information Service (AFIS) is the provision of flight information service to aircraft in the vicinity of an aerodrome. This includes traffic information, weather information, hazards & obstructions, etc.
Generally speaking, an AFIS unit will have either the callsign "Information" (common in Iceland) or "AFIS" (common in Greenland and the Faroe Islands.)
There are two major regulatory environments in which AFIS is provided beneath the Reykjavik CTA: Iceland, and Greenland & EKVG. (Both Greenland and the Faroe Islands have ATS provided by Denmark’s Naviair, so they share similar regulations and procedures.)
These two regulatory environments have different regulations and procedures in certain areas. Where relevant, the procedures below will distinguish between Icelandic and Greenlandic/Faroese operating procedures.
Area of Responsibility
Most AFIS aerodromes have an associated TIZ (Traffic Information Zone – the term used in Greenland/Faroe Islands) or ATZ (Aerodrome Traffic Zone – the term used in Iceland.) Aircraft must be in two-way radio communication with the AFIS unit within the TIZ/ATZ.
Some Icelandic AFIS aerodromes do not have an ATZ. In such cases, aircraft must be in two-way radio communication with the AFIS unit when in the “vicinity of the aerodrome.” This is defined as being within, entering, or leaving the traffic circuit.
Differences from Controlled Aerodromes (Summary)
AFIS officers are not controllers. In general, AFIS units may not issue any clearance or instructions on their own. They may only provide information to pilots, and relay clearances from overlying ATC.
The table below briefly summarizes the key differences between controlled aerodromes and AFIS. For those unfamiliar with AFIS, keep reading — these differences will be discussed in more detail.
Controlled Aerodromes |
AFIS |
“Cleared to…” / “Oceanic clearance to…” |
“Reykjavik Control clears you to…”
(Clearance not issued by AFIS but by overlying ACC) |
“Runway in use… |
ICELAND: The same; AFIS sets active runways.
GREENLAND & EKVG: “Preferred runway is…” |
“Startup approved” / “Push and start approved” |
ICELAND: The same; AFIS gives pushback and startup clearances.
GREENLAND & EKVG: “Startup (or push and start) at your discretion, traffic is…” (or “no traffic on the ground”) |
“Taxi to… via…” |
“Taxiway [X] is available”
OR “Taxiway [X] is occupied, traffic is…”
ICELAND: AFIS may issue taxi instructions within aprons. AFIS may also refuse aircraft permission to enter runways (e.g., “remain clear of runway XX.”) |
“Cleared for takeoff” |
“No reported traffic runway [XX]” |
“Cleared to land” |
|
“Line up and wait” |
“Runway [XX] is occupied, traffic is…” |
“Hold short runway [XX]” / “Hold position” |
|
“After departure leave the control zone…” (VFR departure instructions) |
No equivalent; AFIS does not issue VFR clearances. |
IFR & Oceanic Clearances
When IFR aircraft request clearance:
- The local AFIS unit shall relay the request, including relevant details like the aircraft's Mach number (for oceanic flights), to Reykjavik ACC*.
- *Generally, the lowest sector of Reykjavik Control overlying the aerodrome shall issue the clearance, except for Greenland where Iceland Radio (if online) shall be "first choice" to issue a clearance. See the AFIS quick reference pages for specifics.
- This can be done via any appropriate means of verbal coordination (e.g., Discord VC, VATSIM PMs, etc.)
- Reykjavik ACC will issue the clearance to the AFIS unit.
- The AFIS unit then relays the clearance to the pilot, and verifies the pilot's readback is correct.
If there is no overlying ATC, or if the aircraft will not enter controlled airspace during its flight, then the aircraft should be told to depart at its discretion.
There is no AFIS equivalent to VFR departure, arrival, or circuit clearances. VFR aircraft simply depart and arrive at their discretion.
Runway in Use
Iceland
Icelandic AFIS units determine an active runway the same way as TWR controllers.
Greenland & EKVG
Greenlandic & EKVG AFIS shall not determine an active runway, but may determine a preferred runway using the same criteria as an active runway. The preferred runway is considered advisory information only – aircraft are not required to use this runway.
However, Reykjavik ACC may sometimes clear an aircraft to fly a published instrument procedure (SID, STAR, approach, etc.) for a specific runway. In such cases, aircraft are required to use the runway associated with that procedure. If the aircraft wants to use a different runway, the AFIS unit must coordinate an amended clearance for that aircraft with Reykjavik ACC.
Ground Movements
All movements on taxiways and runways must be performed at the pilot’s discretion. The AFIS unit should provide traffic information to all aircraft moving on the ground regarding which taxiways are available or occupied, and any relevant traffic on the ground.
Iceland
Icelandic AFIS units control all traffic on the movement area outside of runways and taxiways, and have the authority to refuse the entry of aircraft onto runways.
This effectively means that Icelandic AFIS units are also apron controllers. Aircraft should call the AFIS unit for startup clearance, as well as for any pushback or taxiing required on the apron.
Greenland & EKVG
All movements on any part of the movement area, including aprons, shall be performed at the pilot’s discretion. Aircraft shall report starting up, as well as any ground movements (e.g. taxi.)
Takeoff & Landing
AFIS units shall not issue takeoff or landing clearances. If the runway is clear of traffic, then the AFIS unit should inform departing or arriving aircraft that there is “no reported traffic runway XX.” Aircraft, when told this, may line up, depart, or land on the runway at their own discretion. For example:
🎧 FLI402, winds 130 degrees 4 knots, no reported traffic runway 12.
If there is traffic occupying the runway in any way, then the AFIS unit should inform departing aircraft that the runway is occupied and provide traffic information. For example:
🎧 FLI402, runway is occupied, traffic is a company A320 backtracking to vacate the runway.
NOTE: Even if the runway is occupied, aircraft may still use that runway at their discretion. They are only obligated by the rules of the air not to hinder other traffic.
E.g., if one aircraft is vacating at one end of the runway, another aircraft may reasonably choose to line up on the opposite end of the runway, assuming that doing so would not obstruct the path of the vacating aircraft.
Airborne Traffic
As much as possible, AFIS units should proactively offer traffic, weather, and aerodrome information to aircraft in their area of responsibility, in order to facilitate their safe navigation.
Traffic information should generally be provided using procedural methods, since AFIS units do not have radar in Iceland, Greenland, or EKVG. To provide such information, AFIS units may ask aircraft to provide position reports, such as:
- Waypoints/fixes on their route, or on published SIDs, STARs, and approach procedures which the aircraft intends to fly
- Positions relative to the airport, or waypoints/fixes (e.g., abeam the airport, 5 NM from XX NDB, passing waypoint ABCDE, etc.)
- Phases of approach (e.g., final, established on the ILS, etc.)
- Legs of the traffic circuit (e.g., downwind, final, etc.)
Generally speaking, aircraft do not require the AFIS units' permission to leave the frequency once they are outside of the ATZ/TIZ/vicinity of the aerodrome. However, if the aircraft will be entering controlled airspace (e.g., by climbing into it), AFIS should instruct them to contact the relevant ATC unit.
- E.g., at EKVG, aircraft should be instructed to contact Reykjavik Control upon passing 7500ft.
Aircraft arriving an aerodrome (entering the ATZ/TIZ or traffic circuit) should be provided with the active/preferred runway, as well as any relevant traffic information.