Skip to main content

ESSA - Stockholm/Arlanda

Overview

Stockholm Arlanda Airport is Stockholm’s main airport and the largest and busiest airport in Sweden. It is located around 40 km north of the city of Stockholm. The airport was officially opened in 1962, although the first aircraft had landed there several years earlier. Arlanda is serviced by over 70 airlines with around 170 destinations. Around 26 million people pass through the airport annually. Arlanda is also an important cargo hub.

Arlanda originally had two runways (01/19 and 08/26). A third runway, 01R/19L, was opened in 2003 to the east of the airport.

Airport Charts

Parking stands

Available stands

Stand allocation - Who parks where

Who parks where - Arlanda airport website

The airport website shows the real gate for each DEPARTING and ARRIVING flight.

  • Terminal 2 (Stand 62-68) - Schengen and non-Schengen
    • BTI, AFR, BAW, CSA, EZY/EZS, FIN, IBE, KLM, NIA, FPY, RJA, TVF, VUE
  • Terminal 3 (Stand 52-60A) - Closed UFN, parking stands are used as remote stands
    • APF, PNX
  • Terminal 4 (Stand 31-44) - Domestic and Schengen only
    • LOT, NAX/IBK/NOZ/NSZ, RYR, SAS
  • Terminal 5 (Stand 1-20 and F28-F44) - Schengen and non-Schengen
    • AEA, CCA, ASL, AUA, CTN, DAL, UAE, ETH, EWG/EWE/EWL, FIN, FHY/FHM, ICE, DLH, LGL, NAX/IBK/NOZ/NSZ, LBT, NVR, PGT, QTR, SAS, VGK, SXS, SWR, TAP, THA, BLX, THY, UAL
  • Apron E (Stand 101-119) - Remote stands and long-term parking
  • Apron G (Stand G141-G149) - Schengen Turboprops
  • Apron H - SAS Maintenance and long-term parking
  • Apron J - VIP and Ambulance flights
    • EUW, JON, SWE
  • Apron K (Stand K1-K5) - Large GA, VIP flights and long-term parking
  • Apron L - Patria Helicopters (maintenance facility, helicopters refuelling when ESSB closed)
    • POL, DFL, HMF
  • Apron R (Stand R3-R10) - Cargo flights
    • APF, DHL, FDX, KAL, SWN, UPS
  • Apron S - Small GA, cargo and small turboprops

IFR Clearance

At first contact with Clearance Delivery state type of aircraft, stand position and latest received ATIS transmission including identification letter and QNH.

  • If a different runway than the runway-in-use is required for performance reasons, this request shall be made in connection with the request for IFR clearance.
  • If unable to follow FMS/RNAV SID, inform ATC when requesting clearance. Expect to be assigned a SID and to follow the “unable RNAV SID instruction” given in the SID chart.

SID Assignment

Note that unless otherwise instructed, aircraft cleared via SID shall climb to 5000 ft.

Low speed departures

Between 0600 and 2200 local time, low speed aircraft (including most propeller driven aircraft, except ATR 72 and 42, Saab 2000, and Dash 8-Q400 among others) are normally cleared via radar vectoring with initial climb clearance to 3000 ft instead of SID, or via HAPZI SID when RWY 19R is in use.

Startup approval

When simulating A-CDM departure procedures, Clearance Delivery will give a Target Startup Approval Time or TSAT. Report ready to Clearance Delivery within TSAT +/- 5 minutes. Clearance Delivery will give instruction to contact the appropriate Ground frequency. Ground will give approval for startup, and for push-back where required.

Some SID designators are based on a point just before the first flight planned point. For example, if flight planned via ARS and departing RWY 19L the SID could be ARS 5E or ABENI 5Q. Be careful to fly the correct departure.

Push-back

Push-back is generally required for all jet aircraft, unless parked at Terminal 3, Apron R stand R9C, Apron G stand G149 or Apron S stand S71-S79.

Push-back procedure charts available from the Arlanda airport website

If using GSX with an appropriate config file for ESSA, GSX will push you to the standard positions according to the document above.

Use of transponder

The assigned transponder code shall be selected and the transponder activated at the request for push-back. After landing, the transponder shall remain activated until reaching the parking stand and be switched to standby immediately after parking.

Taxi

Unless otherwise instructed by ATC, the standard taxi routes shall be followed.

**

Overview of standard taxi procedures**procedures

Refer to airport charts (Aerodrome ground movement chart/DEPARTURE or ARRIVAL) for actual procedures.

Taxi clearances will normally not include the complete taxi route, as pilots are expected to follow the standard taxi routes. When RWY 01R/19L is in use, pilots will be instructed to use TWY W or U.

Take-off and climb

aircraft cleared via SID shall climb to 5000 ft.

Contact Stockholm Control when instructed by TWR. On initial contact with Stockholm Control report altitude to verify transponder Mode C readout.

If unable to follow FMS/RNAV SID, inform Stockholm Control on initial contact using the phraseology “unable RNAV SID.”

Back to top